Contax SW 2524 - REV A Guía de instalación descargar pdf (Pagina 34)

Installation

1–16 975-0637-01-01 Rev B

This guide for use by qualified personnel only

Installation Tools and Materials

Too ls

You will need the following tools to install the Conext SW and the battery

temperature sensor.

❐ Wire stripper

❐ Crimping tools for fastening lugs and terminals on DC cables

❐ Phillips screwdriver: #2 bit

❐ Slot screwdriver (6mm wide blade max.)

❐ Needle-nose pliers

❐ Wrench for DC terminals and Installation bracket: 5/16" and M6

❐ Power drill/driver

Materials

You will need the following materials to complete your installation:

❐ Strain-relief clamp(s) for AC cables (not provided):

" and

3/4

❐ DC battery cables sized according to Table 1-2 on page 1–14

❐ Terminals and/or crimp connectors for DC cables (3/8" [9.5mm] stud size)

❐ AC and DC disconnect switches and overcurrent protective devices and

connectors as required. See page 1–13

❐ AC output and input wire. See “AC Wiring” on page 1–12

❐ If the AC earth wire is stranded, each earth wire requires a ring terminal

❐ Four M6 screws or bolts to mount the installation bracket to the wall

❐ Four M6 nuts to secure the unit to the installation bracket (supplied)

ConextSWEUROInstallationGuide.book Page 16 Wednesday, December 5, 2012 10:55 AM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 73 74

Sin comentarios

Contax SW 2524 - REV A Guía de instalación Pagina 34