Contax SW 2524 - REV A Guía de instalación descargar pdf (Pagina 23)

Materials List

975-0639-01-01 Rev A 1–5

This guide for use by qualified personnel only

Conext SW AC/DC/Ports Side Panel

Figure 1-4 AC and DC Terminals, Network and Communication Ports Panel

Item Description

1 Battery Positive (+) (red) DC terminal connects to the positive bus bar

of the DC Switchgear.

2 Battery Negative (–) (black) DC terminal connects to the negative bus

bar of the DC Switchgear.

3XANBUS interface ports are used to connect Xanbus-enabled devices

including the optional SCP and AGS.

4STACKING port. Feature not available in this model.

5 Remote (REM) port provides connection for the on/off remote switch.

6 Battery temperature sensor (BTS) port provides connection for the

battery temperature sensor (supplied).

7 AC input/output lines wiring compartment access panel without the

compartment cover.

(a) AC Input terminal block is a screw-type terminal block for attaching

AC input wires. The terminals are labeled INPUT N for Neutral and

INPUT L1 and L2 for split-phase lines 1 and 2 respectively.

(b) AC Output terminal block is a screw-type terminal block for

attaching AC output wires. The terminals are labeled OUTPUT N for

Neutral and OUTPUT L1 and L2 for split-phase lines 1 and 2

respectively.

8 All

 Ground terminals are along the tab (as shown) of the AC wiring

compartment access panel opening.

9 AC knockouts (3/4" and 1") provide access for AC cables (both input

and output wiring). Detach the knockout covers and install strain-relief

clamps available in hardware and electrical stores.

Not

shown

AC wiring compartment cover that is taken out during wiring and put

back in when wiring has been completed.

ConextSW-NA-InstallationGuide.book Page 5 Thursday, December 20, 2012 2:05 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Sin comentarios

Contax SW 2524 - REV A Guía de instalación Pagina 23