Contax SW 2524 - REV A Guía de instalación Pagina 45

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 76
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 44
Inverter/Charger Installation
975-0639-01-01 Rev A 1–27
This guide for use by qualified personnel only
Figure 1-13 Conext SW DC Connections
Battery or Battery
Enclosure
(2)(a)
(1)
Route the DC cables from the battery bank to the DC Switchgear.
(2) Install a DC fuse (a) on the positive cable near the battery terminal.
(3) Open the DC circuit breaker on the DC Switchgear.
(4) Connect one connector on the POSITIVE (+) cable to the POSITIVE terminal on the DC Switchgear. The
connector goes on first, then the flat washer (steel), then the 3/8” (9.5mm) bolt (brass).
(5) Connect the other connector to the POSITIVE (+) terminal on the battery.
(6) Connect one connector on the NEGATIVE (–) cable to the BATTERY NEGATIVE terminal on the DC Switchgear.
(7) Connect the other end of the cable to the NEGATIVE (–) terminal on the battery.
(4)
(5)
(6)
(7)
Terminal Connection
ConextSW-NA-InstallationGuide.book Page 27 Thursday, December 20, 2012 2:05 PM
Vista de pagina 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 75 76

Comentarios a estos manuales

Sin comentarios